LINK-MICRO 4G

CELLULAR TRAIL CAMERA

General

SD cards
  • The LINK-MICRO 4G only works with micro SD cards.
  • Please use a micro SD card between 2 to 32GB capacity.
  • Make sure that you only use Class 4 or Class 10 memory cards.
  • Please format the memory cards before the first use.
Power supply
  • The LINK-MICRO 4G works with 8x R6(AA) batteries, the LIT-10 battery pack or with a 12V battery.
  • Make sure that the batteries are inserted correctly into the battery compartment, otherwise the camera may be damaged.
Status LED
  • During the signal search, the status LED flashes green continuously.
  • When the LINK-MICRO 4G has found a signal, it indicates this using the status LED (green = very good signal; orange = sufficient signal; red = very poor/no signal).
  • The right LED above the lens will now blink for 30 seconds.
  • If the camera has taken a picture, the status LED will be permanently orange during transmission.

Manual

Quick-Start-Guide Multilingual (DE, EN, FR, PL, CZ, SL, FI, ES, IT)

Noch einfügen

TROUBLESHOOTING WIZARD

SOFTWARE

Please note:
Sometimes the versions you can find here may differ from the versions on spypoint.com. The versions listed here have been extensively tested in Europe and run stably. We do not take any responsibility for software versions from other sources!

Version:
V1.18.13-29

Improvements:

  • Small bugs fixed
DOWNLOAD
Installation instructions (PC)
  1. Make sure you use a Class 4, Class 10, or Class 10/U1 micro SD card with up to 32 GB.
  2. Format the SD card. (Video)
  3. Download the software.
  4. Open the downloaded .zip file by double-clicking it.
  5. Copy the files from the .zip file to the micro SD card. (Only the individual files, no folders).
  6. Make sure that the LINK-MICRO 4G is turned off.
  7. Insert the micro SD card into the LINK-MICRO 4G.
  8. Switch on the camera.
  9. The camera will install the update automatically.
  10. As soon as the LINK-MICRO 4G has been updated, it will set itself up again.
Installation instructions (MAC)
  1. Make sure you use a Class 4, Class 10, or Class 10/U1 micro SD card with up to 32 GB.
  2. Format the SD card. (Video)
  3. Download the software.
  4. Open the downloaded .zip file by double-clicking it.
  5. Copy the files from the .zip file to the micro SD card. (Only the individual files, not folders).
  6. On the Micro SD card, right-click MacOS_PrepareSDCard.command and select Open with Terminal to run the file.
  7. Make sure that the LINK-MICRO is turned off.
  8. Insert the micro SD card into the camera.
  9. Switch on the camera.
  10. The LINK-MICRO will install the update automatically.
  11. As soon as the camera has been updated, it will set itself up again.

Subscribe to the newsletter here!

Be the first to know about new products, software updates or promotions at spypoint.store!

To the registration