FLEX-M

Data transmission camera

General

SD cards
  • The FLEX-M only works with micro SD cards
  • Please use a micro SD card with a capacity of between 2 and 512 GB.
  • Make sure that you only use Class 4 or Class 10 memory cards.
  • Please format the memory cards before using them for the first time.
Power supply
  • The FLEX-M works with 8x R6(AA) batteries or the LIT-22 rechargeable battery pack.
  • Make sure that the batteries are inserted correctly in the battery compartment, otherwise the camera may be damaged.
Status-LED

STATUS LED COLOUR

PATTERN

EXPLANATION

Green

Lights permanently

When the camera is triggered or takes a photo or video

Blue

Lights permanently

When a photo or video is transmitted

Blue (flashing)


Flashes every second until reset is complete

Reset to factory settings

Orange

Flashes every second for 30 seconds

Firmware-Update

Red

Lights up permanently
(does not switch off)

No signal found

Red (flashing)

Flashes slowly
(every 2 seconds)

Problem with SIM card / hardware problem

Instruction manual

Quick Start Guide SPYPOINT FLEX-M

QuickStartGuide SPYPOINT FLEX Serie English

SOFTWARE

Please note:
The versions found here may differ from the versions on spypoint.com. The versions listed here have been extensively tested in Europe and are stable. We accept no responsibility for software versions from other sources!

Version:
V1.0.1-9

Improvements:

  • Improved quality image.
  • Enhanced performance of HD requests.
DOWNLOAD
Installation instructions (PC)
  1. Make sure that you use a class 10/U1 micro SD card with up to 512 GB.
  2. Format the micro SD card on a computer in FAT32. (Video)
  3. Download the update file.
  4. Open the downloaded .zip file by double-clicking on it.
  5. Copy the 2 files from the .zip file to the micro SD card. Note: If your SD card was previously FORMATTED with the Flex camera, you have 2 partitions, you must copy the 2 files to the largest partition.
  6. Check whether the copying process on your micro SD card was successful.
  7. Eject the micro SD card from the computer.
  8. Make sure that the camera is switched off.
  9. Insert the micro SD card into the device.
  10. Switch on the camera.
  11. The FLEX-M performs the firmware update automatically for about 5 minutes. The camera will restart several times.
  12. The camera will then go through the connection process.
  13. The firmware of the Flex-M is up to date.
Installation instructions (MAC)
  1. Make sure that you use a class 10/U1 micro SD card with up to 512 GB.
  2. Format the micro SD card on a computer in FAT32. (Video)
  3. Download the update file.
  4. Open the downloaded .zip file by double-clicking on it.
  5. Copy the 2 files from the .zip file to the micro SD card. Note: If your SD card was previously FORMATTED with the Flex camera, you have 2 partitions, you must copy the 2 files to the largest partition.
  6. Check whether the copying process on your micro SD card was successful.
  7. Right-click on MacOS_PrepareSDCard.command on the micro SD card and select Open with Terminal to run the file.
  8. Eject the micro SD card from the computer.
  9. Make sure that the camera is switched off.
  10. Insert the micro SD card into the device.
  11. Switch on the camera.
  12. The FLEX-M performs the firmware update automatically for about 5 minutes. The camera will restart several times.
  13. The camera will then go through the connection process.
  14. The firmware of the Flex-M is up to date.

Subscribe to the newsletter here!

Be the first to know about new products, software updates or promotions at spypoint.store!

To the registration